Calibration and comparison of two moisture content measurement methods for in situ monitoring of beech laminated veneer lumber

A timber bridge constructed in 1815 was renovated in 2018, wherein the load-bearing system was reinforced with beech laminated veneer lumber (LVL) elements. Beech LVL is primarily found in dry and heated structures (Service Class 1). Although the material of this bridge would not be directly exposed to weather, it would be exposed to outdoor relative humidity ranging between 50% in spring and 90% or higher in autumn (Service Class 2). Thus, the moisture content development in the reinforcements was monitored to observe the response of the material under such conditions. The moisture content was measured using both sorptive and electrical resistance methods. The relationship between the electrical resistance of the material to moisture content and sorption isotherms was determined through laboratory experiments. Thereafter, the derived relationships were used to determine the moisture content measured on the bridge over a period of two years. Consequently, the two measurement methods resulted in overlapping of moisture content values, which remained within safe levels and are expected to be maintained in future. The overlapping moisture content measurements validated that either of the monitoring methods could be independently deployed to obtain reliable results.